Ford Mustang System II Remote Starter w/Keyless Entry Kit

              Up to 1500' Range!

Ford Mustang System II Remote Starter w/Keyless Entry Features:

• Includes 2 Ultra-Thin 3-Button Remotes: System 2 includes two chromed-metal reinforced 3-button remotes that will withstand the daily wear & tear of hanging by your keychain and provide optimum performance that get's up to 1500 feet of remote starter, keyless entry and power trunk release activation range.
   
• Safety 2-Press Remote Start Activation: The remote starter is activated by pressing the remote start button on the remote 2X within 3 seconds. This setting helps prevent any accidental activation that could occur with a single press activation setting (system can be ordered for a one press activation if you like and can easily be changed anytime after installation if desired).
   
• Parking Lights Confirmation: Visual confirmation that you activated the remote starter: The system will flash the vehicles parking lights 1X right after you activate the remote starter and then turn the parking lights on solid shortly afterwards to indicate that the vehicle is running via the remote starter.
   
• Pre-Heat/Pre-Cool Activation: Pre-setting your vehicle's heat settings prior to exiting your vehicle will enable you to pre-warm the interior and defrost the windshield when your vehicle is running via the remote starter. Same with the vehicle's AC, just pre-set the AC settings where you like it and it will pre-cool the interior on those hot days from it sitting in the sun.

• Multiple Remote Start Run Times: The system will be set-up for you with whatever run time you wish that's available: Your choices will be 5, 10, 15, 20, 45 or 60 minutes. You can order the system pre-set with any one of these times. 15 minutes is the industry standard. You can easily change the run time yourself anytime after installation.

• Quick-Stop Mode: A cool feature that allows you to keep the engine running without having to leave the keys in the ignition: While the engine is still running with the keys, you press the remote start button on the remote 2X and when you turn off the ignition and remove the keys the engine will remain running for the duration of the remote start run time.

• Safety Brake Pedal Shut-Down Input: Mandatory connection that will immediately shut down the remote starter system if you step on the vehicle's brake pedal before you put the key's into the ignition and turn the ignition on (a.k.a. "key-take-over" feature).

• Valet/Remote Start ON/OFF Mode: The system includes a valet mode where the remote starter feature can be temporarily turned off inhibiting the remotes from being able to activate the system.

• Windshield Mounted Antenna w/Built-In Programming/Valet Button & Status LED: Commonly mounted at the top inside center of the vehicle's windshield directly behind the rear-view mirror for optimal operating range. The antenna conveniently incorporates both the system's programming/valet button and status LED. This eliminates any hole drilling in the vehicle's dash and reduces the amount of wire's needed to be run under the dash during installation.

• Remote Keyless Entry: Lock, Unlock your vehicle's power door locks by remote control from up to 1500' away.

• AVAILABLE OPTIONS:
  Power Trunk/Hatch Release Activation: This system has the capability to activate your vehicle's power trunk or hatch release by remote control (if equipped) from up to 1500' away.
  
  Ignition Controlled Door Lock and/or Unlock: Many newer Mustangs on the road today have auto-locks which locks the vehicle's doors shortly after you begin to drive, if your Mustang is not equipped with this feature you can order this system to provide it. And it can be custom pre-configured for you with in a few ways: Auto-lock with ignition ON only, Auto-lock & unlock with ignition ON/OFF or just unlock doors with ignition OFF. (or completely OFF for Mustangs already with the factory feature)

• For Mustangs with Automatic Transmissions Only!

• Includes Step-by-Step Vehicle Specific Installation Guide w/Color Photos (1994-2014): No sitting with a lap-full of "spaghetti-wire" and jumping from wiring chart to manual, trying to figure out what wires are needed (or not needed) to connect to the vehicle. Each of our VSS system's include a step-by-step, vehicle specific installation manual that indicates exactly what wire from the system connects to what wire in the vehicle, where the wire is located in the vehicle and how to confirm that you found the correct wire using the VSS kits supplied LED style test probe.

• LED Style Test Probe Included: No need for using awkward multi-meters that indicate voltage level's that can confuse polarity readings and require the use of two probes and a bare spot on the wire in order to take a reading. Each of our VSS kits includes an easy to use LED style test probe to use along with the VSS kits step-by-step vehicle specific installation manual. This test probe simplifies the procedure of finding and testing for the correct wire in your vehicle by lighting a green or red LED to indicate the target wire's polarity (explained in each step of our vehicle specific install manuals).
  
  For example, if the step in the VSS guide indicates that the vehicle's parking light wire is a solid blue wire found running into the rear of the vehicle's headlights switch and will show a positive polarity when the parking lights switch is turned on, you simply connect the probes alligator clip to chassis ground, stick the tip of the probe thru the wire's insulation and turn the vehicle's parking light's ON & OFF a few times, and if its the correct blue wire, it will light the red LED in the handle of the test probe at the same time the switch is turned ON & OFF! (again, explained in each step of the VSS manual). It just can't be made any more simpler than this!

• Includes Vehicle Specific NKR ("No Key Required") Bypass Interface Kit: No need to give up one of your vehicles keys (or purchase a 3rd key) in order to install a remote car starter in your vehicle like with most other remote starter kits. The NKR bypass kit included with a VSS system only requires your vehicle's keys for programming, not operation, meaning you don't have to stick one of your keys in a box!
  
  The majority of vehicles on the road today have some type of anti-theft system installed on them from the factory, this can range from the transponder key type typically found in (but not limited to) most Ford, Chrysler/Dodge, Honda and Toyota vehicles to one of several versions of a Passlock system found in most vehicles manufactured by General Motors. When a vehicle is equipped with a factory anti-theft ignition system, an additional bypass interface kit is necessary to install any brand of remote starter system. After ordered, our technicians will know what is required for your specific vehicles installation and include it in with the system.

• Data Bypass/Interface Port: Dedicated input used when installing the additional bypass interface kit required for most vehicles on the road today equipped with factory installed anti-theft systems. This plug-in port eliminates any wiring needed between the remote starter module and the bypass kit (bypass/interface kit included. Wiring between the bypass interface and vehicle required).

• Tachless Monitor Mode: Designed to eliminate the need to run a wire out under the hood to connect to the vehicle's tachometer wire and then having to program the tach signal to the remote starter system: The tachless mode monitors the vehicle's voltage levels, current and crank time everytime the vehicle is started with the keys and during remote start to maintain a trouble-free remote starter activation. Applicable to newer and well maintained vehicle's with gas or hybrid engines only.

• Includes Vehicle Specific Extras: To avoid the inconvenience of getting into the middle of an installation and finding out that you need to stop and run to the auto parts store for a relay or radio shack for some resistor's or whatever, we include any needed extra relays w/harness (for example, for power trunk activation, 3rd Accessory etc.) and/or diodes, resistors, voltage inverters, etc. needed for your specific vehicle.

• Installation Connector Package: Each VSS system includes 3 different size's of quick-connect "T-Tap" connectors with male spade connectors pre-crimped to the ends of the systems wiring for making quick connections from the system to your vehicle's wiring. Also included are crimp cap connectors for connecting wires end-to-end and self-tapping screws with ground loop connectors for making chassis ground connections to the vehicle. Nylon zip ties are also supplied for securing wiring, control module and sensor placement.

• Lifetime Technical Support: Have access to some of the most qualified technicians in the industry, 7 days a week. Providing technical support since 2002, each member of our technical support staff has a minimum of 10 years of hands-on experience installing alarms, keyless entry and remote car starter systems. And with one of the largest support networks in the industry, our technicians can be directly contacted via phone, email, through our massage board, support forum and even by txt. With our wide-range of communication options, if you ever have a problem or question you can feel confident that you can easily contact someone in our technical support department.

• 30 Day Money Back Guarantee: With 1000's of VSS systems sold over the last decade we are confident that you'll be more than satisfied with the quality and service of our VSS kits that if for whatever reason after receiving and evaluating your VSS system that your not satisfied with your purchase you can return the system to us for a full refund within 30 days from date-of-delivery. Even if you think it's a great system but feel you can't tackle the job yourself and can't find anyone to install it for you, you can return it before attempting any installation.