In any situation where the Flashlogic module does not program properly due to a mistake made during the programming procedure or from a faulty or wrong connection or servicing of the vehicle, it is required to reset and reprogram the Flashlogic module to the vehicle using the procedure below:
Step 1: Unplug all harnesses away from the Flashlogic module making sure you unplug the black 4-pin plug last:
Step 2: First, Press & hold in the small black push button on the Flashlogic module, while still holding in the button, plug in just the black 4-pin plug: Response: The LED on the Flashlogic module will begin flashing RED, when this is seen release the button: Response: The LED will turn ON Solid RED for a few seconds then turn OFF, after this is seen, plug in the remaining harnesses to the Flashlogic module:
Step 3: The LED on the Flashlogic module will be steadily flashing GREEN. While the LED is steadily Flashing GREEN, press & hold in the small black push button on the Flashlogic module until the LED lights up Solid GREEN for 1 second and turns OFF, then release the button. The module is now reset and ready for vehicle specific programming to the vehicle: Repeat vehicle specific FLASHLOGIC PROGRAMMING to the vehicle step in your manual.